HydroGadget Protoboard Build

It’s alive! Sometimes protoboard builds are not exactly great looking.  This power supply board is a good example.  I’m rather pleased however, how the output board came out.  I couldn’t locate a fuse of the right size so I just dropped a machine screw I had laying around so I could run tests.  The power supply board passed a 1.5A load stress test for a full hour with no signs of distress.  Should be ready to go for Las Vegas Mini Maker Faire!

Power supply board:
IMG_0736[1]

Output board:
IMG_0738[1]

-Eric

Leave a Reply

Your email address will not be published. Required fields are marked *

I iknow it is annoying, but at least it is better than those stupid image captcha things! *